Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Melrose?
Garage door work in Melrose typically runs $150 – $600 for most repairs, while a full new door installation lands between $700 – $2,200. The most common call we get – a broken spring – is usually $180 – $340 for a single spring, and since springs are replaced in matched pairs, a pair costs about twice that. Every price we quote is set per job by a written estimate, and the estimate itself is free.
That range holds across Melrose because most of the housing stock here is older – plenty of homes date to the early 1900s through the 1950s, with a wave of mid-century ranches and capes mixed in. Older doors sit on older hardware, and the age of the tracks, rollers, and opener often shapes what a repair actually costs more than the door’s size does.
We’re a garage door specialist, not a general handyman who takes garage door calls between drywall jobs. Every job is a garage door. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor products, so the technician who shows up has seen your brand’s failure patterns before. Call (844) 793-4614. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Typical garage door repair in Melrose: $150 – $600.
- Single spring replacement: $180 – $340. A matched pair costs about twice that.
- New door installation: $700 – $2,200, depending on size, material, and insulation.
- Opener repair runs $120 – $320; a new opener installed is $250 – $550.
- Estimates are free, and the written estimate sets the final price.
Garage Door Cost Breakdown (2026)
These are typical estimated ranges for the Melrose market in 2026. Your written estimate is the number that matters – it’s built from your actual door, your actual hardware, and the parts your job needs.
| Service | Typical estimated range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
A single spring replacement is priced for one spring. If your door has a matched pair – and most two-car doors do – both get replaced together, so expect roughly double the single-spring range. Replacing one spring on a paired door and leaving the other in place is false economy: the older spring is already fatigued, and it usually fails within a year, meaning you pay for the same job twice.
What pushes a job toward the top of a range? Rusted or bent track that needs realignment before anything else can be done. A door with a broken panel that also needs the opener recalibrated. A legacy opener where a circuit board is the failure point rather than the motor. What keeps a job at the bottom? Standard failure types – a snapped torsion spring, a frayed cable, a worn roller set – on hardware that’s otherwise sound.
We also handle jobs that cross categories. If your opener is fine but the door is pulling hard, or the door is sound but the opener’s connectivity has dropped off, we diagnose the whole system rather than one part in isolation. Full scope from one provider means repair, spring work, opener electronics, and installation are all handled in-house – no subcontracting, no gaps between trades.
What Affects Garage Door Pricing in Melrose
Melrose is an old suburb with a specific character: narrow streets off Main Street and the Wyoming and Cedar Park neighborhoods, steep driveways in places, and a lot of homes where the garage was added later or retrofitted into an existing structure. That shapes pricing in ways a generic national price guide won’t tell you.
- The age of the hardware, not the door. A 1950s door with original tracks and rollers may look solid but be running on components that need replacement before a new spring can be safely installed. We check the full system, not just the failed part, because a new spring on worn cables will fail again quickly.
- Spring type and door weight. Torsion springs, which mount horizontally above the door, are the standard on most Melrose homes. Extension springs, mounted along the sides, are common on older doors. The two aren’t interchangeable, and the spring must be sized to the door’s actual weight. An undersized spring fails prematurely; an oversized one puts strain on the opener and cables.
- Opener age and brand. Smart openers from LiftMaster and Chamberlain involve circuit board and connectivity diagnostics. Legacy openers, including older Craftsman and Genie units, often fail at the motor or the safety sensor rather than the electronics. Brand-specific diagnosis changes the labor involved.
- Door material and insulation. A basic steel Clopay or Amarr door sits at the low end of installation pricing. Insulated doors, carriage-house styles, and wood-look doors from Wayne Dalton and Raynor move toward the top. If your garage is attached and you use the space, insulation matters for more than the door’s appearance.
- Track condition and alignment. Tracks bend when a door is forced or when a car clips a rail. A bent track means the door can’t travel cleanly, and realignment has to happen before springs or opener work make sense. In older Melrose garages, tracks are sometimes mounted to framing that has shifted over the decades.
- Panel damage and matching. A dented or cracked panel can often be replaced without a full door, but matching an older profile or color can affect availability. If the door is a discontinued model, a panel replacement may not be possible and the conversation shifts to a full replacement.
One local note: winters here are hard on the moving parts. Road salt tracked onto the garage floor, freeze-thaw cycles, and months of the door cycling in cold temperatures all wear rollers, hinges, and cables faster than in milder climates. That’s why we see so many roller and cable jobs in Melrose alongside spring failures – the two tend to go together on a door that’s been neglected for a few seasons.
How to Save on Garage Door
The biggest savings come from catching a problem before it becomes two problems. A worn roller set that gets replaced at $110 – $220 is cheaper than the same worn rollers that eventually chew through a cable and force a combined repair. Here’s how to keep costs down:
- Fix the small stuff early. A door that’s getting noisy, running slightly crooked, or reversing unpredictably is telling you something. A quick diagnosis now avoids a bigger bill later.
- Replace springs in pairs. If one spring on a paired door has failed, replace both. It costs more upfront but saves you a second service call – and a second spring – within the year.
- Lubricate the moving parts. Rollers, hinges, and the spring itself benefit from a proper garage door lubricant a couple of times a year. Not WD-40 – a real lubricant. It’s the cheapest maintenance there is.
- Keep the door balanced. If the door feels heavy or slams down, the springs or cables need attention. An unbalanced door strains the opener, and opener repairs run $120 – $320 that you may not need.
- Get the free estimate in writing. We give you a written estimate before any work starts, and that estimate sets the final price. No surprises when the job is done. Call (844) 793-4614 for yours.
What we won’t do is sell you a new door when a repair will do. If your door is structurally sound and the hardware is serviceable, a repair is the right call. If the door is at the end of its life – cracked panels, bent track, an opener that’s older than the door – we’ll tell you that too, and quote a replacement honestly. Our business is garage door repair in Somerville and the surrounding area, and that means giving you the right answer for your door, not the most expensive one.
Spring Repair: The Safety-Critical Job
Torsion springs and the cables that run with them are under extreme tension. A spring under load can cause serious injury if it releases unexpectedly, and the tools and technique required to wind and unwind one safely are not something to attempt without training. We say this plainly because it’s the honest answer: spring and cable work is not a DIY job. If your spring has snapped, keep the door closed and don’t try to force it open. Call us instead.
Spring repair is a core service for us, not an upsell tucked onto the end of a tune-up. It’s also one of the most commonly neglected failures – homeowners put up with a heavy door or a door that won’t stay up for months before calling, and by then the cables and opener have taken a beating too. Handling it in-house means we can diagnose the spring, size the replacement correctly, and check the cables and opener in the same visit, so the door comes back balanced and safe. Our technicians have up to 11 years of experience with high-tension spring work.
Opener Repair and Installation Costs in Melrose
Opener problems are the second most common call we get in Melrose, and they’re not all the same. A door that won’t respond to the remote might be a battery, a safety sensor, or a circuit board. A door that hums but doesn’t move might be a stripped gear or a failed capacitor. Diagnosing by brand and symptom matters: a LiftMaster with a connectivity issue is a different repair than an older Genie with a motor problem.
Opener repair runs $120 – $320 for typical issues. If the opener is at the end of its life – which is common on doors that are 15-plus years old – a new opener installed is $250 – $550. We install and service LiftMaster, Chamberlain, Genie, and Craftsman openers, and we can pair a new opener to your existing door or advise when a door replacement makes better sense.
If you’re locked out with the door down and the opener dead, that’s when emergency service matters. Emergency garage door service is part of our standard offering, not a premium tier. Call (844) 793-4614. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Same-day service is often possible.
New Door Installation: When to Replace Instead of Repair
New door installation in Melrose runs $700 – $2,200 for typical residential doors. The low end covers a basic steel door in a standard size. The high end covers insulated doors, larger openings, and premium profiles from Clopay, Amarr, Wayne Dalton, and Raynor.
When does replacement beat repair? When the door has multiple cracked panels, when the track is beyond realignment, or when the opener and door are both at end of life and you’d be paying for two repairs in a year anyway. When the door is structurally sound and only the hardware has failed, repair is almost always the better value. We’ll give you both numbers in the estimate so you can decide with real figures in front of you.
Installation includes removing the old door, fitting the new one, and setting up the opener and safety sensors. We handle it all in-house – one call, full scope, no subcontractors.
FAQs – Garage Door Cost
How much does garage door repair cost in Melrose?
Most garage door repairs in Melrose cost $150 – $600. That range covers typical spring, cable, roller, and track jobs. Call (844) 793-4614 for an exact quote – estimates are free, and the written estimate sets the final price.
How much does spring repair cost in Melrose?
Spring repair costs $180 – $340 for one spring. A matched pair is usually replaced together, so a pair costs about twice that. Call (844) 793-4614 to get a quote for your door.
Is it cheaper to repair or replace a garage door?
Repair is cheaper in most cases: a repair runs $150 – $600 versus $700 – $2,200 for a new door installed. Replacement makes sense when the door has multiple failed panels, bent tracks that can’t be realigned, or both the opener and door are at end of life. The written estimate shows both options when relevant.
Can you come today if my door won’t open?
Often yes – same-day service is part of how we work. Call (844) 793-4614. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. If the door is stuck closed with a car inside, tell us when you call and we’ll prioritize it.
Do you charge for an estimate?
No, the estimate is free, and it’s written. The price is set per job by that written estimate, so the number you agree to is the number you pay. Call (844) 793-4614 to schedule yours.
Do you work on my brand of door or opener?
Yes, if it’s one of the eight we know inside out: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. We diagnose by brand-specific failure patterns rather than guesswork. Call (844) 793-4614 and have your door or opener brand ready if you know it.
Why do prices vary so much between companies?
Part quality, spring sizing, and whether the repair covers the whole system or just the failed part. A quote that only covers one spring on a paired door, or that skips checking the cables, may look cheaper but can cost more within a year. Ask what’s included, and get it in writing. Our free estimates spell out exactly what’s covered.
Every job in Melrose is quoted from your actual door, not a chart. The ranges on this page are typical for the 2026 market, and the written estimate is what sets your final price. Call (844) 793-4614 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The door that moves every day deserves a specialist.
Pricing reflects the Melrose market as of 2026. Somerville Garage Door Repair Pros offers free estimates – call (844) 793-4614.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Sarah Novak"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Greg Sullivan"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Carrie Parker